Administrator Guide

The following describes the interface vlan command shown in the following
example. This example shows unconfiguration of the hybrid port using the no
portmode hybrid
command.
NOTE: Remove all other configurations on the port before you can remove
the hybrid configuration from the port.
Example
Dell(conf)#interface gi 7/0
Dell(conf-if-gi-7/0)#portmode hybrid
Dell(conf-if-gi-7/0)#interface vlan 10
Dell(conf-if-vl-10)#untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#tagged gi 7/0
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: GigabitEthernet 7/0
802.1QTagged: Hybrid
Vlan membership:
Vlan 10, Vlan 20
Native VlanId: 10
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged gi 7/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged gi 7/0
Dell(conf-if-vl-20)#interface gi 7/0
Dell(conf-if-gi-7/0)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
Commands
show interfaces switchport — displays the configuration of switchport (Layer 2)
interfaces on the switch.
switchport — places the interface in a Layer 2 mode.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN
network.
rate-interval
Configure the traffic sampling interval on the selected interface.
Z9000
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
Interfaces
651