Administrator Guide

Example
Dell(conf)#interface range gigabitethernet 1/1 - 2
Dell(conf-if-range-gi-1/1-2)#show config
!
interface GigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface GigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-gi-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Z9000
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For stack-units, enter the keywords stack-unit then
the slot/port information. The range is from 0 to 11.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.2) Added support for the tunnel interface type.
Version 9.1(0.0) Updated ManagementEthernet output to include two global
IPv6 addresses on S4810 and Z9000 and added output
example showing OpenFlow instance ID.
654
Interfaces