Administrator Guide

Version 8.3.12.1 Updated command output to support multiple IPv6
addresses on S4810.
Version 8.3.11.4 Output expanded to support eSR4 optics in Z9000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series
and C-Series output.
Version 8.2.1.0 Added support for 4093 VLANs on the E-Series ExaScale.
Prior releases supported 2094.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Output expanded to include SFP+ media on the C-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Changed the organization of the display output.
Version 6.3.1.0 Added the Pluggable Media Type field in the E-Series
TeraScale output.
Usage
Information
Use the show interfaces command for details on a specific interface.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For
receive/transmit power that is less than 0.000, an snmp query returns the
corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until
it reaches the maximum line rate. When the maximum line rate is reached,
there is no change in the line-rate.
User
Information
The following table describes the show interfaces command shown in the 10G
(TeraScale) Example below.
Line Description
TenGigabitEthern
et 0/0...
Interface type, slot/port, and administrative and line
protocol status.
Hardware is... Interface hardware information, assigned MAC address, and
current address.
Pluggable media
present...
Present pluggable media wavelength, type, and rate. The
error scenarios are:
• Wavelength, Non-qualified — Dell Force10 ID is not
present, but wavelength information is available from
XFP or SFP serial data
Interfaces
655