Administrator Guide

Vlan 2
--More--
Related
Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces transceiver — displays the physical status and operational status of
an installed transceiver. The output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port
] transceiver
Parameters
tengigabitether
net
For a 10G interface, enter the keyword
tengigabitethernet then the slot/port information.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the
slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on theS6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Output augmented with diagnostic data for pluggable media.
Version 7.7.1.0 Removed three fields in the output: Vendor Name, Vendor
OUI, and Vendor PN.
670
Interfaces