Administrator Guide

Related
Commands
interface port-channel — creates a port channel interface.
interface vlan — creates a VLAN.
show ip interface — displays the interface routing status. Add the keyword brief
to display a table of interfaces and their status.
speed (for 10/100/1000 interfaces)
Set the speed for 10/100/1000 Base-T Ethernet interfaces. Set both sides of a link to the same speed
(10/100/1000) or to auto or the link may not come up.
Z9000
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed {10 | 100 | 1000}
command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-
EH-GE-50P or the LC-EJ-GE-50P card. If the command
is entered for these interfaces, an error message appears.
100 Enter the keyword 100 to set the interface’s speed to 10/100
Mb/s.
NOTE: When this setting is enabled, only 100Base-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
1000 Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s. Auto-negotiation is enabled. For more information,
refer to negotiation auto.
NOTE: When this setting is enabled, only 100oBase-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to negotiation auto.
Defaults auto
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
678
Interfaces