Administrator Guide

1000 Enter the keyword 1000 to set the interface to auto-
negotiate its speed.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed.
Defaults auto
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the S55, S60, and S4810
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage
Information
This command is found on the Management interface only.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with
the speed set to 10/100.
management route — configures a static route that points to the Management
interface or a forwarding router.
stack-unit portmode
You can split a single 40G port into four-10G ports.
Z9000
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset. For the Z9000, the range is from 0 to 7.
680
Interfaces