Administrator Guide

Usage
Information
If an IP address or VRRP group is assigned to the interface, you cannot use the
switchport command on the interface. To use the switchport command on an
interface, only the no ip address and no shutdown statements must be
listed in the
show config output.
When you enter the switchport command, the interface is automatically added
to the default VLAN.
To use the switchport backup interface command on a port, first enter the
switchport command. For more information, refer to the “Configuring
Redundant Links” section in the “Layer 2” chapter of the
Dell Networking OS
Configuration Guide.
Related
Commands
interface port-channel — creates a port channel interface.
show interfaces switchport — displays information about switchport interfaces.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Configure the management egress interface selection.
Z9000
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all | application-type} command.
Parameters
application-
type
Enter any of the following keywords:
• For DNS, enter the keyword dns.
• For FTP, enter the keyword ftp.
• For NTP, enter the keyword ntp.
• For Radius, enter the keyword radius.
• For sFlow collectors, enter the keyword sflow-
collector
.
• For SNMP (traps and MIB responses), enter the keywords
snmp .
• For SSH, enter the keyword ssh .
• For Syslog, enter the keyword syslog.
• For TACACS, enter the keyword tacacs.
Interfaces
683