Administrator Guide

• For Telnet, enter the keyword telnet.
• For TFTP, enter the keyword tftp.
all Configure all applications.
Defaults None.
Command
Modes
EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Introduced on the Z9000, S4810, and S4820T.
application (for HTTP and ICMP)
Configure the management egress interface selection for HTTP and ICMP.
NOTE: Only the options that have been newly introduced are described here. For a complete
description on all of the keywords and variables that are available with this command, refer the
respective Command Reference Guide of the applicable platform of the Release 9.2(0.0)
documentation set.
Z9000
Syntax
application {all | application-type}
To remove a management application configuration, use the no application
{all | application-type} command.
Parameters
application-
type
Enter any of the following keywords:
• For HTTP, enter the keyword http.
• For ICMP, enter the keyword icmp.
all Configure all applications.
Defaults None.
Command
Modes
EIS Mode (conf-mgmt-eis)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
684
Interfaces