Administrator Guide

Version 9.2.
(0.0)
Introduced on the Z9000, S4810, and S4820T.
Example
Dell#show management application pkt-fallback-cntr
dns : 0
ftp : 0
ntp : 0
radius : 0
sflow-collector : 0
snmp : 0
ssh : 2
syslog : 0
tacacs : 0
telnet : 0
tftp : 0
Port Channel Commands
A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link
according to IEEE 802.3ad. In Dell Networking OS, a LAG is referred to as a Port Channel.
• For the S-Series, the maximum port channel ID is 128 and the maximum members per port channel is
8.
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least
one port, some of those nominally available Port Channels might have no function because they could
have no members if there are not enough ports installed. In the S-Series, stack members can provide
those ports.
NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you configure
a LAG on both switches manually. For information about Dell Networking OS link aggregation
control protocol (LACP) for dynamic LAGs, refer to the
Link Aggregation Control Protocol (LACP)
chapter. For more information about configuring and using Port Channels, refer to the Dell
Networking OS Configuration Guide.
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Z9000
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member
interface command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
688
Interfaces