Administrator Guide

show config
Display the current configuration of the selected LAG.
Z9000
Syntax
show config
Command
Modes
INTERFACE PORTCHANNEL
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
Dell(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
Dell(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
Z9000
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-
number
For a Port Channel interface, enter the keyword port-
channel then a number. For the C-Series and S-Series, the
range is from 1 to 128.
brief (OPTIONAL) Enter the keyword brief to display only the
port channel number, the state of the port channel, and the
number of interfaces in the port channel.
Interfaces
695