Administrator Guide

Related
Commands
debug ip udp-helper — enables debug and displays the debug information on a
console.
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface either
for all UDP ports or a specified list of UDP ports.
Enhanced Validation of Interface Ranges
This functionality is supported on the Z9000 platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you
configure by using the interface range command. For example, if you enter a list of interface ranges,
such as
interface range fo 2/0-1,te 10/0,gi 3/0,fa 0/0, this configuration is considered
valid. The comma-separated list is not required to be separated by spaces in between the ranges. You
can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-
address-table static multicast-mac-address vlan vlan-id output-range interface
command.
ip http source-interface
Specify an interface as the source interface for HTTP connections.
This feature is supported on Z9000 platform.
Syntax ip http source-interface interface
To delete an interface, use theno ip http source-interface interface command.
Parameters
interface
Enter the following keywords and slot/port or number
information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For Loopback interfaces, enter the keyword loopback
followed by a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel followed by a number:
– S-Series: 1-128
Interfaces
707