Administrator Guide

arp max-entries
Enables you to configure the maximum number of ARP entries per VRF that are allowed for IPv4..
Syntax
arp max-entries [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the name of a specific VRF for which you want to
configure maximum number of ARP entries that IPv4 allows.
max-number Enter the maximum number of ARP entries that a VRF RTM
can hold. The range is from 0 to 65535.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S4810 and S4820T.
Usage
Information
Use this command to specify the maximum number of ARP entries that the Route
Table Manager can hold for a specific VRF. This command does not apply to the
management VRFs.
arp retries
Set the number of ARP retries in case the system does not receive an ARP reply in response to an ARP
request.
Z9000
Syntax
arp retries number
Parameters
number Enter the number of retries. The range is from 1 to 20. The
default is 5.
Defaults 5
Command
Modes
CONFIGURATION
720
IPv4 Routing