Administrator Guide

Related
Commands
show ip fib stack-unit — shows FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
Z9000
Syntax
clear ip route {* | ip-address mask}
Parameters
* Enter an asterisk (*) to clear all learned IP routes.
ip-address
mask
Enter a specific IP address and mask in dotted decimal
format to clear that IP address from the routing table.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
You cannot use this attribute to clear routes corresponding to a management VRF.
Related
Commands
ip route — assigns an IP route to the switch.
show ip route — views the routing table.
IPv4 Routing
725