Administrator Guide

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced for the E-Series.
Usage
Information
To avoid denial of service (DOS) attacks, keep the number of fragments allowed for
re-assembly low.
ip max-routes
Enables you to configure the maximum number of protocol routes per VRF that are allowed for IPv4.
Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF for
which you want to configure maximum number of protocol
routes that IPv4 allows.
max-number Enter the maximum number of protocol routes that a VRF
RTM can hold. The range is from 0 to 7500.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S4810 and S4820T.
Usage
Information
Use this command to specify the maximum number of protocol routes that the
Route Table Manager can hold for a specific VRF. This command does not apply to
the management VRFs.
IPv4 Routing
745