Administrator Guide

Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added support for 4094 VLANs on the E-Series ExaScale (the
prior limit was 2094).
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Using the following example of a static route: ip route 33.33.33.0 /24
tengigabitethernet 0/0 172.31.5.43
• The software installs a next hop that is not on the directly connected subnet but
which recursively resolves to a next hop on the interface’s configured subnet. In
the example, if gig 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43
recursively resolves to 2.2.2.0, Dell Networking OS installs the static route.
• When the interface goes down, Dell Networking OS withdraws the route.
• When the interface comes up, Dell Networking OS re-installs the route.
• When recursive resolution is “broken,” Dell Networking OS withdraws the route.
• When recursive resolution is satisfied, Dell Networking OS re-installs the route.
Related
Commands
show ip route — views the switch routing table.
ip source-route
Enable Dell Networking OS to forward IP packets with source route information in the header.
Z9000
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source
command.
Defaults Enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv4 Routing
751