Administrator Guide

tcp-udp enable Enter the keywords to distribute traffic based on the
following:
• enable — Takes the TCP/UDP source and destination
ports into consideration when doing hash computations.
This option is enabled by default.
ingress-port
enable
Enter the keywords to distribute traffic based on the
following:
• enable — Takes the source port into consideration when
doing hash computations. This option is disabled by
default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0
Added the ingress-port parameter for the S4810.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
By default, Dell Networking OS distributes incoming traffic based on a hash
algorithm using the following criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
IPv4 Routing
755