Administrator Guide

pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
Z9000
Syntax
show arp [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static |
dynamic] [inspection {database | statistics][summary]
Parameters
interface
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For the Management interface, enter the keyword
managementethernet then the slot/port information.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
ip ip-address
mask
(OPTIONAL) Enter the keyword ip then an IP address in the
dotted decimal format. Enter the optional IP address mask in
the slash prefix format (/ x).
inspection Enter the keyword inspection with one of the following
keywords to view ARP entries:
• database — view a list of ARP entries learned using DAI
IPv4 Routing
759