Administrator Guide

show ip cam stack-unit
Display CAM entries for a port-pipe of a stack-unit on a S-Series or Z-Series switch.
Z9000
Syntax
show ip cam stack-unit {id} [port-set {pipe-number} {ip-address
mask [longer-prefixes [ecmp-group detail]]}| ecmp-group {detail
| member-info [detail [group-index index-number]]}| summary]
Parameters
id Enter the stack-unit ID. The unit ID range is from 0 to 7 for
the Z9000.
port-set pipe-
number
Enter the keyword port-set then the number of the stack
unit’s port-pipe. The unit ID range is from 0 to 3 for the
Z9000.
network mask
[longer-
prefixes [ecmp-
group detail]]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. You can enter one of the
following keywords to filter results.
• Enter the keyword longer-prefixes to view routes
with a common prefix.
• Enter the keyword ecmp-group detail to view the
ECMP group index.
ecmp-group
{detail |
member-info
[detail [group-
index index-
number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the
following keywords to filter results.
• Enter the keyword detail to view the ECMP group
index.
• Enter the keyword member-info to view the member
information for the ECMP group.
• Enter the keyword member-info detail to view
detailed ECMP membership and n-hop information.
• Enter the keyword group-index then the index number
to show ECMP membership per group. The range is from
0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
768
IPv4 Routing