Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip fib command shown in the following
example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
Index Displays the internal interface number.
EC Displays the number of ECMP paths.
Example
Dell>show ip fib linecard 12
Destination Gateway First-Hop Mac-Addr
Port VId Index EC
---------------------------------------------------------------
-----------------
3.0.0.0/8 via 100.10.10.10, So 2/8 100.10.10.10
00:01:e8:00:03:ff So 2/8 0 60260 0
3.0.0.0/8 via 101.10.10.10, So 2/9
00.10.10.0/24 Direct, So 2/8 0.0.0.0
00:01:e8:00:03:ff So 2/8 0 11144 0
100.10.10.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 3276 0
100.10.10.10/32 via 100.10.10.10, So 2/8 100.10.10.10
00:01:e8:00:03:ff So 2/8 0 0 0
101.10.10.0/24 Direct, So 2/9 0.0.0.0
00:00:00:00:00:00 RP2 0 11145 0
101.10.10.1/32 via 127.0.0.1 127.0.0.1
IPv4 Routing
771