Administrator Guide

Usage
Information
The following describes the show ip fib stack-unit command shown in the
following example.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a
directly connected route or the remote IP address used to
forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
EC Displays the number of ECMP paths.
Example
Dell#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-
Addr Port VId EC
---------------------------------------------------------------
----------------------------
1.1.1.2/32 via 1.1.1.2, Vl 1000 1.1.1.2
00:01:00:00:00:02 Te 7/42 1000 0
2.1.1.2/32 via 2.1.1.2, Vl 20 2.1.1.2
00:03:00:00:00:02 Po 10 20 0
0.0.0.0/0 - 0.0.0.0
00:00:00:00:00:00 CP 0 0
1.1.1.0/24 Direct, Vl 1000 0.0.0.0
00:00:00:00:00:00 CP 1000 0
1.1.1.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 0
2.1.1.0/24 Direct, Vl 20 0.0.0.0
00:00:00:00:00:00 CP 20 0
2.1.1.1/32 via 127.0.0.1 127.0.0.1
00:00:00:00:00:00 CP 0 0
100.1.1.0/24 via 1.1.1.2, Vl 1000 1.1.1.2
00:01:00:00:00:02 Te 7/42 1000 1
100.1.1.0/24 via 2.1.1.2, Vl 20 2.1.1.2
00:03:00:00:00:02 Po 10 20 1
Dell#
Related
Commands
clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
IPv4 Routing
773