Administrator Guide

Fields Description
Protocol States whether IP is enabled (up) or disabled (down) on the
interface.
Example (Brief)
Dell#show ip int brief
Interface IP-Address OK? Method
Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively
down down
GigabitEthernet 1/1 unassigned NO Manual administratively
down down
GigabitEthernet 1/2 unassigned YES Manual
up up
GigabitEthernet 1/3 unassigned YES Manual
up up
GigabitEthernet 1/4 unassigned YES Manual
up up
GigabitEthernet 1/5 10.10.10.1 YES Manual
up up
GigabitEthernet 1/6 unassigned NO Manual administratively
down down
show ip management-route
View the IP addresses assigned to the Management interface.
Z9000
Syntax
show ip management-route [all | connected | summary | static]
Parameters
all (OPTIONAL) Enter the keyword all to view all IP addresses
assigned to all Management interfaces on the switch.
connected (OPTIONAL) Enter the keyword connected to view only
routes directly connected to the Management interface.
summary (OPTIONAL) Enter the keyword summary to view a table
listing the number of active and non-active routes and their
sources.
static (OPTIONAL) Enter the keyword static to view non-active
routes also.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
778
IPv4 Routing