Administrator Guide

cp Enter the keyword cp to view only TCP information from the
Control Processor.
rp1 Enter the keyword rp1 to view only TCP statistics from
Route Processor 1.
rp2 Enter the keyword rp2 to view only TCP statistics from
Route Processor 2.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 6.4.1.0 Introduced
Usage
Information
The following describes the show tcp statistics cp command shown in the
following example.
Field Description
Rcvd: Displays the number and types of TCP packets received by
the switch.
• Total = total packets received
• no port = number of packets received with no
designated port
0 checksum
error...
Displays the number of packets received with the following:
• checksum errors
• bad offset to data
• too short
329 packets... Displays the number of packets and bytes received in
sequence.
17 dup... Displays the number of duplicate packets and bytes
received.
790
IPv4 Routing