Administrator Guide

booted Enter the path to the upgrade source. Entering <CR> updates
the FPGA from the flash.
file-url Enter the following location keywords and information to
upgrade the FPGA using an Dell Networking OS image other
than the one currently running:
• To specify an Dell Networking OS image on the internal
flash, enter flash:// file-path/filename.
• To specify an Dell Networking OS image on an FTP
server, enter ftp:// user:password@hostip/
filepath
.
• To specify an Dell Networking OS image on the external
flash on the primary RPM, enter slot0://file-path/
filename
.
• To copy a file on a TFTP server, enter tftp://hostip/
filepath/ filename where hostip is either an IPv4
dotted decimal address or an IPv6 URI [x:x:x:x::x] format
address..
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z-Series.
Version 8.3.1.0 Added the rpm option.
Version 7.5.1.0 Introduced on the C-Series.
Example
Dell#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
Dell#
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
80
File Management