Administrator Guide

Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced.
Usage
Information
This command allows you to create an EUI64 address based on the specified prefix
and MAC address only. Prefixes may be configured on the interface using the ipv6
nd prefix command without creating an EUI64 address.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
Z9000
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
Parameters
pps Enter the maximum number of error packets generated per
second. The range is from 1 to 200, where 0 disables the
rate-limiting.
Default 100 pps
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
808
IPv6 Basics