Administrator Guide

Usage
Information
When the interface goes down, Dell Networking OS withdraws the route. The route
is re-installed, by Dell Networking OS, when the interface comes back up. When a
recursive resolution is “broken,” Dell Networking OS withdraws the route. The route
is re-installed, by Dell Networking OS, when the recursive resolution is satisfied.
After an IPv6 static route interface is created, if an IP address is not assigned to a
peer interface, the peer must be manually pinged to resolve the neighbor
information.
Example
Dell(conf)#ipv6 route ?
X:X:X:X::X IPv6 prefix x:x::y
Dell(conf)#ipv6 route 44::0 ?
/nn /nn Mask in slash format
Dell(conf)#ipv6 route 44::0 /64 ?
X:X:X:X::X Forwarding router's address
gigabitethernet Gigabit Ethernet interface
loopback Loopback interface
null Null interface
port-channel Port-Channel interface
tenGigabitethernet TenGigabit Ethernet interface
fortyGigE FortyGigabit Ethernet interface
tunnel Tunnel interface
vlan Vlan interface
Dell(conf)#ipv6 route 44::0 /64 33::1 ?
<1-255> Distance metric for this route
permanent Permanent route
tag Set tag for this route
Dell(conf)#ipv6 route 44::0 /64 33::1
Dell(conf)#ipv6 route 44::0 /64 tengigabitethernet 0/1 ?
X:X:X:X::X Forwarding router's address
Dell(conf)#ipv6 route 44::0 /64 tengigabitethernet 0/1 66::1
Dell(conf)#
Related
Commands
show ipv6 route — views the IPv6 configured routes.
ipv6 unicast-routing
Enable IPv6 Unicast routing.
Z9000
Syntax
ipv6 unicast-routing
To disable unicast routing, use the no ipv6 unicast-routing command.
Defaults Enabled
Command
Modes
CONFIGURATION
816
IPv6 Basics