Administrator Guide

4
Control and Monitoring
This chapter contains the commands to configure and monitor the system, including Telnet, file transfer
protocol (FTP), and trivial file transfer protocol (TFTP) as they apply to the following Dell Networking
Z9000 platform.
NOTE: Starting in version 8.3.11.4, the enable xfp-power-updates command was deprecated
for the Z9000.
This command replaces the enable optic-info-update interval command
to update information on temperature and power monitoring in the simple network management
protocol (SNMP) management information base (MIB).
asf-mode
Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.
Z9000
Syntax
asf-mode stack-unit {unit-id | all} queue size
To return to standard Store and Forward mode, use the no asf-mode stack
unit command.
Parameters
unit-id Enter the stack member unit identifier of the stack member
to reset. The Z9000 range is from 0 to 7. The range is from 0
to 11.
queue size Enter the queue size of the stack member. The range is from
0 to 15.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.0 Introduced on the Z9000.
82
Control and Monitoring