Administrator Guide

Version 8.3.7.0 Introduced on the S4810.
Usage
Information
You must save the configuration and reload the system to implement ASF. When
you enter the command, the system sends a message stating that the new mode is
enabled when the system reloads.
banner exec
Configure a message that is displayed when your enter EXEC mode.
Syntax
banner exec c line c
To delete a banner, use the no banner exec command.
Parameters
c Enter the keywords banner exec, then enter a character
delineator, represented here by the letter c. Press ENTER.
line Enter a text string for your banner message ending the
message with your delineator. In the following example, the
delineator is a percent character (%); the banner message is
“testing, testing”.
Defaults No banner is displayed.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original Command
Usage
Information
After entering the banner login command, type one or more spaces and a
delineator character. Enter the banner text then the second delineator character.
When the user is connected to the router, if a message of the day banner is
Control and Monitoring
83