Administrator Guide

Usage
Information
How a metric value assigned to a redistributed route is advertised depends on how
on the configuration of the metric-style command. If the metric-style
command is set for Narrow mode and the metric value in the redistribute
ospf
command is set to a number higher than 63, the metric value advertised in
LSPs is 63. If the metric-style command is set for wide mode, the metric value
in the
redistribute ospf command is advertised.
router isis
Allows you to enable the IS-IS routing protocol and to specify an IP IS-IS process.
Z9000
Syntax
router isis [tag]
To disable IS-IS routing, use the no router isis [tag] command.
Parameters
tag (OPTIONAL) This is a unique name for a routing process. A
null tag is assumed if the tag option is not specified. The tag
name must be unique for all IP router processes for a given
router.
Defaults Not configured.
Command
Modes
ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
Configure a network entity title (the net command) to specify the area address and
the router system ID.
Enable routing on one or more interfaces to establish adjacencies and establish
dynamic routing.
882
Intermediate System to Intermediate System (IS-IS)