Administrator Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
Use this command to confirm that the neighbor adjacencies are operating
correctly. If you suspect that they are not, you can verify the specified area
addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the
following example.
Field Description
System Id The value that identifies a system in an area.
Interface The interface, slot, and port in which the router was
discovered.
State The value providing status about the adjacency state. The
range is Up and Init.
Type This value displays the adjacency type (Layer 2, Layer 2 or
both).
Priority IS-IS priority the neighbor advertises. The neighbor with
highest priority becomes the designated router for the
interface.
Uptime Displays the interfaces uptime.
Intermediate System to Intermediate System (IS-IS)
891