Administrator Guide

To disable a configuration, use the no mac learning-limit station-move-
violation command, then the configured keyword.
Parameters
log Enter the keyword log to generate a syslog message on a
station move violation.
shutdown-both Enter the keyword shutdown to shut down both the original
and offending interface and generate a syslog message.
shutdown-
offending
Enter the keywords shutdown-offending to shut down
the offending interface and generate a syslog message.
shutdown-
original
Enter the keywords shutdown-original to shut down the
original interface and generate a syslog message.
Defaults none
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
Usage
Information
This command is supported on physical interfaces, static LAGs, and LACP LAGs.
Related
Commands
show mac learning-limit — displays details of the mac learning-limit.
mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
Z-Series
Syntax
mac learning-limit reset
Defaults none
Layer 2
921