Administrator Guide

Column Heading Description
• te — 10 Gigabit Ethernet then a slot/port.
State Lists if the MAC address is in use (Active) or not in use
(Inactive).
Example
Dell(conf)#do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId Mac
Address Type Interface State
2 00:00:00:00:00:01 Dynamic (N) Po
128 Active
2 00:00:00:00:00:02 Dynamic (N) Po
10 Active
2 00:00:00:00:00:03 Dynamic Po
100 Active
2 00:00:00:00:00:04 Dynamic Po
10 Active
Usage
Information
The following describes the show mac-address-table command shown in the
following example.
Column Heading Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured
(Static), learned (Dynamic), or associated with a specific port
(Sticky). An (N) indicates that the specified MAC address has
been learnt by a neighbor and is synced to the node.
Interface Displays the interface type and slot/port information. The
following abbreviations describe the interface types:
• gi — Gigabit Ethernet followed by a slot/port
• po — Port Channel followed by a number. Range for
Terascale is from 1 to 255. \
• so — Sonet followed by a slot/port.
• te — 10–Gigabit Ethernet followed by a slot/port.
State Lists if the MAC address is in use (Active) or not in use
(Inactive).
The following describes the show mac-address-table count command shown
in the following example.
Line Beginning
With
Description
MAC Entries... Displays the number of MAC entries learned per VLAN.
Dynamic
Address...
Lists the number of dynamically learned MAC addresses.
Layer 2
927