Reference Guide

Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf statistics process-id global
command shown in the following example.
Row Heading Description
Total Displays the total number of packets the OSPF process receives/
transmits.
Error Displays the error count while receiving and transmitting packets by
the OSPF process.
Hello Number of OSPF Hello packets.
DDiscr Number of database description packets.
LSReq Number of link state request packets.
LSUpd Number of link state update packets.
LSAck Number of link state acknowledgement packets.
TxQ-Len The transmission queue length.
RxQ-Len The reception queue length.
Tx-Mark The highest number mark in the transmission queue.
Rx-Mark The highest number mark in the reception queue.
Hello-Q The queue, for transmission or reception, for the hello packets.
LSR-Q The queue, for transmission or reception, for the link state request
packets.
Other-Q The queue, for transmission or reception, for the link state
acknowledgement, database description, and update packets.
The following describes the error definitions for the show ip ospf statistics
process-id global command.
Error Type Description
Intf_Down Received packets on an interface that is either down or OSPF is not
enabled.
Non-Dr Received packets with a destination address of ALL_DRS even
though SELF is not a designated router.
Self-Org Receive the self originated packet.
Wrong_Len The received packet length is different to what was indicated in the
OSPF header.
1014