Reference Guide

• The hello-timer remaining value for each interface
• The wait-timer remaining value for each interface
• The grace-timer remaining value for each interface
• The packet count received and transmitted for each neighbor
• Dead timer remaining value for each neighbor
• Transmit timer remaining value for each neighbor
• The LSU Q length and its highest mark for each neighbor
• The LSR Q length and its highest mark for each neighbor
Example
(Statistics)
FTOS#show ip ospf 100 statistics
Interface GigabitEthernet 0/8
Hello-Timer 9, Wait-Timer 0, Grace-Timer 0
Error packets (Only for RX)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unkown-Pkt 0
Neighbor ID 9.1.1.2
Hello DDiscr LSReq LSUpd LSAck
RX 59 3 1 1 1
TX 62 2 1 0 0
Dead-Timer 37, Transmit-Timer 0
LSU-Q-Len 0, LSU-Q-Wmark 0
LSR-Q-Len 0, LSR-Q-Wmark 1
Related
Commands
clear ip ospf statistics — clears the packet statistics in all interfaces and neighbors.
show ip ospf timers rate-limit
Show the LSA currently in the queue waiting for timers to expire.
Z9000
Syntax
show ip ospf process-id timers rate-limit
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
1016