Reference Guide

debug ipv6 ospf bfd
Display debug information and interface types for bidirectional forwarding detection (BFD) on OSPF IPv6 packets.
Z9000
Syntax
[no] debug ipv6 ospf bfd [interface]
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a tunnel interface, enter the keyword tunnel then a
number. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2.(0.0) Introduced on the S4820T, S4810, and Z9000.
Usage
Information
The following section describes the command fields.
Lines Beginning
With or Including
Description
OSPFv3... Debugging is on for all OSPFv3 packets and all interfaces.
05:21:01 Displays the time stamp.
Sending Ver:3 Sending OSPF3 version..
Example
FTOS(conf-if-te-0/2)#do debug ipv6 ospf bfd te 0/2
OSPFv3 bfd related debugging is on for TenGigabitEthernet 0/2
00:59:26 : OSPFv3INFO: Received Interface mode bfd config
command on interface Te 0/2 Enable 1, interval 0, min_rx 0,
Multiplier 0, role 0, Disable 0
00:59:26 : OSPFv3INFO: Enabling BFD on interface Te 0/2 Cmd
Add Session
00:59:27 : OSPFv3INFO: Enabling BFD for NBRIP
fe80:0000:0000:0000:0201:e8ff:fe8b:7720
00:59:27 : OSPFv3INFO: Completed Enabling BFD on interface Te
0/2
1025