Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.4.1.1 Introduced on the E-Series ExaScale.
Usage
Information
The following describes the show ip pim snooping neighbor commands shown in
the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM
snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-
enabled neighbor was discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the
amount of time until the neighbor is removed from the multicast
routing table (that is, until the neighbor hold time expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
FTOS#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Gi 4/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Gi 4/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Gi 4/20 ] 00:00:51/00:01:24 v2 0
show ip pim snooping tib
Display information from the tree information base (TIB) PIM-SM snooping discovered about multicast group members
and states.
Syntax
show ip pim snooping tib [vlan vlan-id] [group-address [source-
address]]
1069