Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length for RP selection. The range is
from 0 to 128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election process.
The range is from 0 to 255. The default is 0.
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The
range is from 0 to 4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
1077