Reference Guide

show ipv6 pim tib
View the IPv6 PIM multicast-routing database (tree information base — tib).
Syntax
show ipv6 pim tib [group-address [source-address]]
Parameters
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format
to view RP mappings for a specific group.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
source-address (OPTIONAL) Enter the source address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
Example
FTOS#show ipv6 pim tib
PIM Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, L - Local, P -
Pruned,
R - RP-bit set, F - Register flag, T - SPT-bit set, J -
Join SPT,
M - MSDP created entry, A - Candidate for MSDP
Advertisement
K - Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(25::1, ff0e::225:1:2:1), uptime 00:09:53, expires
00:00:00,flags: CJ
RPF neighbor: GigabitEthernet 10/3, fe80::201:e8ff:fe00:6265
Outgoing interface list:
GigabitEthernet 10/11
(25::1, ff0e::225:1:2:2), uptime 00:09:54, expires
00:00:00,flags: CJ
RPF neighbor: GigabitEthernet 10/3, fe80::201:e8ff:fe00:6265
Outgoing interface list:
1086