Reference Guide

Parameters
dot1p0 value ...
dot1p7 value
Enter a dot1p list number and value. The list number range is from 0 to
7. The range is from 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p Priority: 0 1 2 3 4 5 6 7
• CoS Queue: 0 0 0 1 2 3 3 3
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
Related
Commands
show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
Z9000
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic
dot1p command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
1122