Reference Guide

GigabitEthernet 5/0-1,5-6,10-11,15,17,19,21
ICMP packet debugging is on for
GigabitEthernet 5/0,2,4,6,8,10,12,14,16
FTOS#
show inventory
Display the S-Series or Z-Series switch type, components (including media), and FTOS version, including hardware
identification numbers and configured protocols.
Z9000
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media then the stack ID of the stack
member for which you want to display pluggable media inventory.
NOTE: This parameter is available but not supported in FTOS
version 8.3.11.4. Because stacking is not supported, if you use this
parameter, the output displays “Media not present or accessible”
(refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4 optics.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced this version of the command for S-Series. S-Series output
differs from E-Series.
Usage
Information
If there are no fiber ports in the unit, just the header under show inventory media displays. If
there are fiber ports but no optics inserted, the output displays Media not present or
accessible .
Example (S-
Series)
FTOS#show inventory
System Name : S50v
system Mode : 1.0
Software Version : 7.6.1.0a
Unit Type Serial Number Part Number Revision
--------------------------------------------------------------
115