Reference Guide

• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
database (OPTIONAL) Enter the keyword database to display messages
when there is a change to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol
changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger
extensions.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
default-information originate
Generate a default route for the RIP traffic.
Z9000
Syntax
default-information originate [always] [metric metric-value]
[route-map map-name]
To return to the default values, use the no default-information originate
command.
Parameters
always (OPTIONAL) Enter the keyword always to enable the switch
software to always advertise the default route.
metric metric-
value
(OPTIONAL) Enter the keyword metric then a number as the metric
value. The range is from 1 to 16. The default is 1.
1167