Reference Guide

Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers
are possible.
To ensure that only specific interfaces are receiving and sending data, use the passive-
interface
command with the neighbor command.
Related
Commands
passive-interface — sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this command.
Z9000
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You cannot
specify a subnet.
Defaults No RIP network is configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
1177