Reference Guide

interval Time, in seconds, the alarm monitors the MIB variables; this is the
alarmSampleType in the RMON alarm table. The range is from 5 to
3600 seconds.
delta Enter the keyword delta to test the change between MIB variables.
This is the alarmSampleType in the RMON alarm table.
absolute Enter the keyword absolute to test each MIB variable directly.
This is the alarmSampleType in the RMON alarm table.
rising-threshold
value event-
number
Enter the keywords rising-threshold then the value (32 bit) the
rising-threshold alarm is either triggered or reset. Then enter the
event-number to trigger when the rising threshold exceeds its limit.
This value is the same as the alarmRisingEventIndex or alarmTable of
the RMON MIB. If there is no corresponding rising-threshold event,
the value is zero.
falling-threshold
value event-
number
Enter the keywords falling-threshold then the value (32 bit)
the falling-threshold alarm is either triggered or reset. Then enter the
event-number to trigger when the falling threshold exceeds its limit.
This value is the same as the alarmFallingEventIndex or the
alarmTable of the RMON MIB. If there is no corresponding falling-
threshold event, the value is zero.
owner string (OPTIONAL) Enter the keyword owner then the owner name to
specify an owner for the alarm. This is the alarmOwner object in the
alarmTable of the RMON MIB.
Defaults owner
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
1192