Reference Guide

rmon collection history
Enable the RMON MIB history group of statistics collection on an interface.
Z9000
Syntax
rmon collection history {controlEntry integer} [owner name]
[buckets number] [interval seconds]
To remove a specified RMON history group of statistics collection, use the no rmon
collection history {controlEntry integer} command.
Parameters
controlEntry
integer
Enter the keyword controlEntry to specify the RMON group of
statistics using a value. Then enter an integer value from 1 to 65535
that identifies the RMON group of statistics. The integer value must
be a unique index in the RMON history table.
owner name (OPTIONAL) Enter the keyword owner then the owner name to
record the owner of the RMON group of statistics.
buckets number (OPTIONAL) Enter the keyword buckets then the number of
buckets for the RMON collection history group of statistics. The
bucket range is from 1 to 1000. The default is 50.
interval seconds (OPTIONAL) Enter the keyword interval then the number of
seconds in each polling cycle. The range is from 5 to 3600 seconds.
The default is
1800 seconds.
Defaults none
Command Modes CONFIGURATION INTERFACE (config-if)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
1193