Reference Guide

protocol spanning-tree rstp
To configure RSTP, enter RSTP mode.
Z9000
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use
the no disable command from RSTP mode.
Example
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
Related
Commands
disable — disables RSTP globally on the system.
show config
View the current configuration for the mode. Only non-default values are displayed.
Z9000
Syntax
show config
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
1211