Reference Guide

access-class
Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
Z9000
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
access-list-name Enter the name of an established IP Standard ACL.
Defaults Not configured.
Command Modes LINE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
line — applies an authentication method list to the designated terminal lines.
ip access-list standard — names (or selects) a standard access list to filter based on the IP
address.
ip access-list extended — names (or selects) an extended access list based on the IP
addresses or protocols.
enable password
Change the password for the enable command.
Z9000
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the level of
access. The range is from 1 to 15.
1233