Reference Guide

ReAuth Max: 2
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 3600 seconds
Max-EAP-Req: 2
Auth Type: SINGLE_HOST
Auth PAE State: Initialize
Backend State: Initialize
FTOS#
SSH Server and SCP Commands
FTOS supports secure shell (SSH) protocol versions 1.5 and 2.0. SSH is a protocol for secure remote login over an
insecure network. SSH sessions are encrypted and use authentication.
crypto key generate
Generate keys for the SSH server.
Z9000
Syntax
NOTE: Some of the parameters in this command require licensing to access. For more
information, contact your Dell Networking representative.
crypto key generate {rsa | rsa1}
Parameters
rsa Enter the keyword rsa then the key size to generate a SSHv2 RSA
host keys. The range is from 1024 to 2048 if you did not enable FIPS
mode; if you enabled FIPS mode, you can only generate a 2048-bit
key. The default is 1024.
NOTE: You must have a license to access the FIPS mode. For
more information, contact your Dell Networking representative.
rsa1 Enter the keyword rsa1 then the key size to generate a SSHv1 RSA
host keys. The range is from 1024 to 2048. The default is
1024.
NOTE: This option is not available in FIPS mode.
Defaults Key size 1024; if you enable FIPS mode, the key size is 2048.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
1265