Reference Guide

ip ssh authentication-retries
Configure the maximum number of attempts that should be used to authenticate a user.
Z9000
Syntax
ip ssh authentication-retries 1-10
Parameters
1-10 Enter the number of maximum retries to authenticate a user. The
range is from 1 to 10. The default is 3.
Defaults 3
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command specifies the maximum number of attempts to authenticate a user on an SSH
connection with the remote host for password authentication. SSH disconnects when the
number of password failures exceeds authentication-retries.
ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
Z9000
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10 Enter the number of maximum numbers of incoming SSH connections
allowed per minute. The range is from 1 to 10 per minute. The default
is
10 per minute.
Defaults 10 per minute
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
1268