Reference Guide

sflow extended-switch enable
Enable packing information on a switch only.
Z-Series
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable]
command.
Parameters
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
FTOS version 7.8.1.0 and later enhances the sflow implementation for real time traffic analysis
on the E-Series to provide extended gateway information in cases where the destination IP
addresses are learned by different routing protocols and for cases where the destination is
reachable over ECMP.
Related
Commands
sflow extended-gateway enable — enables packing information on an extended gateway.
sflow extended-router enable — enables packing information on a router.
show sflow — displays the sFlow configuration.
1299