Reference Guide

sflow polling-interval (Global)
Set the sFlow polling interval at a global level.
Z-Series
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value Enter the interval value in seconds. The range is from 15 to 86400
seconds. The default is 20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
The polling interval for an interface is the maximum number of seconds between successive
samples of counters sent to the collector. This command changes the global default counter
polling (20 seconds) interval. You can configure an interface to use a different polling interval.
Related
Commands
sflow polling-interval (Interface) — sets the polling interval for an interface.
sflow polling-interval (Interface)
Set the sFlow polling interval at an interface (overrides the global-level setting.)
Z-Series
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
1300