Reference Guide

Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Sample-rate is the average number of packets skipped before the sample is taken. This
command changes the global default sampling rate. You can configure an interface to use a
different sampling rate than the global sampling rate. If the value entered is not a correct
power of 2, the command generates an error message with the previous and next power of 2
value. Select one of these two packet numbers and re-enter the command.
Related
Commands
sflow sample-rate (Interface) — changes the interface sampling rate.
sflow sample-rate (Interface)
Change the interface default sampling rate.
Z-Series
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series, the
range is from 256 to 8388608 packets.Enter values in powers of 2 only;
for example, 4096, 8192, 16384, etc. The default is the Global default
sampling.
Defaults The Global default sampling.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
1302